![]() I added a row of black trim braid along the hem.Īfter I divided my piece of fabric in half to make two lengths of fabric (one for the front, and one for the back), I trimmed off a length from one side that I used for the waistbands and the ties. I made an apron style skirt, omitting the dip in the front. I had a piece of gray woven fabric, I think it was a wool blend. Item Costume design for Johnny Casino Item Costume design for Marty and. My picture of the apron and the blouse together didn’t turn out, so, we’ll move on to the skirt. Item Costume design for Patti in cheerleading outfit Item Costume design. Once the table runner was stabilized by stitching down the pleats, I sandwiched it between the open spot in the sash and stitched it together. I marked the center front and the edges of the desired width (this I didn’t use in the end, as I used the fabric pattern on the table runner to determine the width, instead of a measurement). In the center (shown below) I left it open. I stitched the ends together like a tube and turned them so all the edges were finished. ![]() I used some scrap black fabric and cut enough to make a sash. I pleated the top together to create a pattern, and stitched each pleat down about 3″ from the top. ![]() I then stitched the two halves together to make a wider piece, matching the stripe. I had found a woven table runner in some nice coordinating colors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |